Eastey ERX-15 Automatic Case Erector
The ERX-15 Case Erector enables a single operator to form,
seal, and pack corrugated cases. Operation is simple: load up to 200 cases in
the case magazine hopper and set your operation to run or jog mode. Separators
release the leading blank case where a series of eight vacuum suction cups hold
the case in a properly formed square position. After a set of stationary flaps
folding bars fold both minor and major bottom flaps, the case is then transitioned,
and the bottom is sealed with Eastey’s proven EX tape head.
The versatile design of the ERX-15 allows operators the
flexibility of making adjustments on the fly without tools and easy-to-use hand
tighten knobs and cranks. Need to switch case sizes? No problem, case
changeover is completed in minutes for a wide range of cases as large as 19.5”
in length, 19.5” in height, and 15.5” in width.
Speed – Up to 15 cases a minute.
Case Sealing – 2” wide pressure sensitive tape, optional 3”
wide
Case Hopper Capacity – 150-200 cases (200 cases w/ B-flutes)
Machine Dimensions – 94.3”(L) 82”(W) 82.8”(H)
Electrical Requirements – 110V, 50/60HZ, 1-PH
Air Requirements – 80 PSI @ 12 CFM
Minimum Box Size – 7″ (Length) 5″ (Width) 5″ (Depth)
Maximum Box Size – 19.5″ (Length) 15.5″ (Width) 19.5″
(Depth)
Case Types – RSC – RH or LH
Flute Types – A, B, and C-flutes; 3-5mm
Wall Types – Single
See more information here:
Eastey ERX-15
Case Erector
Comments
Post a Comment